Figure 4 � Audio Connections
Dashed lines (����) indicate coaxial and optical
digital audio connections. Choose either type
but not both
Figure 5 � Connecting EzSet/EQ Microphone
Step 4. Connect AM and FM antennas (Fig. 4) (see page 16).be reassigned. Connect the component, composite and S-VideoOwnerOs Manual and the on-screen menus to run EzSet/EQ. Note that
Step 5. Connect source components, as shown in Figures 4 and 5, and theMonitor outputs to your Video Monitor (TV). Switch your TV setOs inputyou will hear a series of test tones and will then be instructed to move
Device Connection Options chart on the back of this guide (see pagesto match the type of video used for the currently selected source.the microphone and point it toward the three front speakers during the
16�17).Step 6. Plug all components into AC power outlets. The outlets on the back ofsecond part of the calibration process. When the on-screen menu indi-
AUDIO connections: Right channel (red) on source to right (red) the AVR 635 should be used only for low-current products, such ascates that EzSet/EQ is complete, your system settings for speakers,
on AVR, and left channel (white) on source to left (white) on AVR.CD or DVD players, and the total should not exceed 100 watts.delay times, channel output and room equalization are entered into the
DIGITAL AUDIO connections, if available: Choose either coaxialBasic Receiver ConfigurationunitOs memory. Unplug the microphone and keep it for future use.
(orange) to coaxial (orange) OR optical to optical for each device.Step 7. Select digital inputs: If your DVD is connected to Coaxial 1, no adjust-Step 9. Your system is configured � sit back and enjoy.
The Coaxial 1 input defaults to the DVD player; however, it may bement is needed. For any other digital-device connections, use the
reassigned. Assign the other digital inputs and outputs as appropriatefront-panel Digital Select button and the arrow buttons to select an
see Step 7see pages 21 and 35
VIDEO connections: Choose component (Y/Pb/Pr � green/blue/Step 8. Plug the EzSet/EQ microphone into the Microphone Jack behind the
red), composite (yellow) or S-Video (4-pin) for each video source.door on the front panel. Place the microphone at your preferred listen-
The DVD Component Video inputs default to the DVD player, but maying position and then follow the instructions on pages 24 to 26 of the
SPEAKER AND AUDIO CONNECTIONS |
ACEC
